Oase ProfiClear Guard, Руководство по эксплуатации

Страница: 22 / 215

- EN -
22
3.4 The solenoid valve functions as follows
The solenoid valve converts the electrical signal from the level control unit into a mechanical opening
or closing movement. The solenoid valve is closed when there is no electric current.
3.5 Intended use
Only use the product described in this manual as follows:
•
For maintaining the water level of a pond by topping it up with water from the mains water supply
(drinking water).
The following restrictions apply to the unit:
•
The drinking water may only enter the pond via a free flowing outlet (with air gap separation).
•
Ensure that the pond has an overflow that drains the excess water into the sewer system.
• Operate in accordance with instructions. (→ Technical data)
• The solenoid valve may not be used as a safety valve.
•
Only operate the unit with the provided plugs/connectors and cables.
4 Installation
4.1 Installing the solenoid valve
N O T E
• The installation of the solenoid valve described in the following may only be performed by a
trained plumber.
•
Ensure that excess water (pond overflow water) can drain via a pond overflow or other
suitable protective measure into the sewer system.
How to proceed:

D
•
The drinking water supply pipe intended for connection must be thoroughly flushed out to ensure
that the function of the solenoid valve is not impaired by any residue.
•
Remove the protective plugs from both ends of the solenoid valve.
• Connect the solenoid valve to the drinking water supply pipe. Ensure that the arrow on the bottom
of the valve points in the flow direction of the drinking water.
– OASE recommends: Fit the strainer in front of the solenoid valve in order to prevent the ingress
of dirt, and thus malfunctions of the solenoid valve.
– OASE recommends: Fit the solenoid valve with the solenoid pointing upward. This increases its
operating life and reduces calcium and dirt deposits.
•
Fit the pipe with male thread G½ to the outlet (OUT) of the solenoid valve.
• Complete the installation with a free flowing outlet (with air gap separation).

C
•
OASE recommends: Direct the water flowing out of the free flowing outlet (9) (with air gap separa-
tion) through a DN 50 pipe (11) or larger, or via a water course into the pond.
4.2 Fitting the level control unit
All cables are permanently connected to the level control unit and cannot be disconnected.
How to proceed:

E
1. Loosen each of the 4 screws on the transparent cover by turning 90° counter-clockwise and remove
the transparent cover (the screws remain in the cover).
2. Insert each of the four supplied screws (3.5

30 mm) into a through hole and affix the level control
unit to a suitable wall.
3. Replace the transparent cover, then push in each of the 4 screws one after another and tighten by
turning 90° clockwise.