![background image](http://html1.mh-extra.com/html/oase/lunaqua-power-led-series/lunaqua-power-led-series_operating-instructions-manual_3155305014.webp)
- EN -
14
Wall or floor installation
How to proceed:
E, C
Drill 2 holes in a firm base or in a load bearing wall.
– Drill each 5 mm hole at least 35 mm deep.
Undo the short socket head cap screws and remove.
Remove the base plate.
Loosen the fastening screws on the spotlight head.
Tilt the spotlight head.
Fasten the spotlight.
– Use the wall plugs and screws provided.
Slightly loosen the fastening screws on both sides of the spotlight.
Tilt the spotlight as required.
Tighten the fastening screws again.
Ceiling installation
•
The supplied wall plug is not approved for use in ceilings and must not be used for this purpose!
Fastening a single spotlight to a nozzle extension
How to proceed:
F
Undo and remove the fastening screws from the spotlight head of one spotlight.
Remove the spotlight from the mounting bracket.
Undo the short socket head cap screws and remove.
Remove the base plate.
Turn the mounting bracket into the indicated position, fit it onto the nozzle extension and screw it on with the base plate
on the opposite side.
Fasten the spotlight onto the mounting bracket again using the fastening screws.
– The spotlight head should point upwards in the direction of the nozzle.
– The connection cable should hang down freely near the nozzle tube.
Fastening spotlights in pairs to a nozzle extension
How to proceed:
G
Undo and remove the fastening screws from the spotlight head of two spotlights.
Remove the spotlights from the mounting brackets.
Undo the short socket head cap screws and remove.
Remove the base plates.
Turn the mounting brackets into the indicated positions, fit them to each side of the nozzle extension and screw to-
gether.
– Use washers and nuts.
Fasten each spotlight to its mounting bracket again using the fastening screws.
– The spotlight head should point upwards in the direction of the nozzle.
– The connection cable should hang down freely near the nozzle tube.
Establishing the connections
Connecti on
Each spotlight can either be connected directly or with the aid of one or more 10 m LunAqua Power LED extension
cables (42636) to the driver. The maximum cable length between spotlight and driver should not exceed 45
m.
A spacer must be used between the connection cable and extension cable.
How to proceed:
H, I
Remove the protection cap from the driver.
Fit the plug connector and secure with the two screws (max. 2.0
Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
Содержание LunAqua Power LED Series
