Oase Lunaqua 35, Инструкция по применению

Страница: 7 / 44

7
GB Operating instructions GB
Changing the bulb (fig.1)
1. Turn off the light or the safety tranformer and ensure that it cannot be accidently
turned on.
2. Loosen the screws of the upper section.
3. Remove the upper section and the glass and clean, if ecessary.
4. Remove the bulb from the fitting and replace. Do not touch the glass of the bulb
with your hand.
5. Take note of the power information on the bulb.
6. Check the O-ring and replace it if damaged.
7. Reassemble the parts in the reverse order.
Technical data
Lunaqua 35
Rated voltage 12 V / 50 Hz
Power consumption 35 W
Spread of light 24°
Transformer
Rating 35VA
Primar voltage 230 V / 50 Hz
Secondary voltage 12V
— Attention: The built-in temperature switch cuts off the device if it overheats
(fault) and switches it on again automatically once it has cooled down.
Subsequently, proceed as follows:
— Disconnect the transformer from the power supply.
— Eliminate the cause of the fault.
— When installing the transformer, ensure that it is far enough away from the
lamp to prevent it from being additionally heated up by the heat radiating from
the lamp.
— The installed capacity of the lamp may not exceed the capacity of the
transformer as specified by the type plate.
Assembly (fig. 1 - 7)
— Assemble the swivel bracket (fig. 5).
— Place the nut into the hole in the side.
— Set the swivel bracket into position and lightly screw the bolt into the nut.
— Secure the bracket in position using the screws.
— Connect the spotlight and the OASE safety transformer using the secondary
side plug connector.
— Position the spotlight so that it does not present a danger to anyone.
— For use in the pond attach the spotlight to a suitable base (stone) using the swivel
bracket.
— For use outside the pond use the stake and the swivel bracket.
— Insert the connector of the safety transformer into the socket fig. 2).
— Check the function of the spotlight.
Lunaqua35 Exp.p65 28.03.2003, 09:23 7