Oase BioTec ScreenMatic2, Руководство по эксплуатации

Страница: 34 / 326

- EN -
34
6.4 Time-dependent cleaning
The ScreenMatic rotating screen unit executes a cleaning cycle after a set interval depending on the ambient
temperature. This ensures cleaning at regular intervals
x
if the sensor is soiled or defective,
x
if there is very little soiling on the screen and/or low flow rates (e.g. when the SFC of the filter pump is acti-
vated).
Ambient temperature Interval Rotational movement of the ScreenMatic screen
”௔ƒ&
6 hours One rotation forward
x
The debris is conveyed into the debris tray. ௔ƒ&௔«௔௔ƒ&
4 hours
•௔ƒ&
3 hours
6.5 System messages
LED Malfunction Possible cause Remedy Resetting the system
message
Flashes
green/red No automatic cleaning cy-
FOHZLWKLQ௔KRXUV
Sensor soiled – Clean the sensor.
– Descale the sensor. Automatic reset after rem-
edy of malfunction
No flow of water Filter pump is not operating Start up the filter pump.
No water detected by the
sensor Control device incorrectly posi-
tioned Correctly position the control de-
vice
Control device defective Replace the control device.
Insufficient conductivity of the
water Increase the water hardness with
OptiPond
Insufficient pump capacity Adjust the pump capacity accord-
ingly
Flashes red 20 automatic cleaning cy-
cles in succession ScreenMatic screen soiled – Start manual the cleaning
cycle and use a brush to
clean the ScreenMatic
screen on the side of the
ZDWHUGLVWULEXWRUĺௗ
Manual
cleaning)
– Clean the ScreenMatic
screen from the inside if the
mesh is clogged by a bio-
ILOPĺௗ
Cleaning/replacing
the ScreenMatic screen)
Automatic reset after rem-
edy of malfunction
Sensor soiled Clean the sensor.
Control device incorrectly posi-
tioned Correctly position the control de-
vice
Pump capacity too high Adjust the pump capacity accord-
ingly
Flashes green ScreenMatic screen not ro-
tating although a manual
cleaning cycle was trig-
gered. Motor cable plug not connected
or incorrectly connected to the
control device Connect the plug, check that it is
correctly seated. –
Motor defective Replace motor
Off ScreenMatic screen not ro-
tating although a manual
cleaning cycle was trig-
gered. Connection cable plug not con-
nected or incorrectly connected
to the transformer Connect the plug, check that it is
correctly seated. –
Transformer not connected to
the mains voltage Connect the transformer to the
mains voltage.
Transformer defective Replace transformer
Control device defective Replace the control device.