Oase Biorb 46000, Руководство по эксплуатации

Страница: 19 / 176

- EN -
19
N O T E
• Before connecting, ensure that the heater is
immersed in water at least up to the marking
for the minimum immersion depth.
N O T E
•
Switch off the heater and allow it to cool
down before removing it from the water.
•
Do not leave the heater unattended after re-
moving it from the water.
How to proceed:

F
•
Wait approx. 30 minutes before switching on
so that the thermostat can adjust to the tem-
perature of the water.
•
Route the power connection cable such that
it forms a drip loop!
• Switching on: Connect the unit to the mains.
The unit switches on immediately.
•
Switching off: Disconnect the unit from the
mains.
Checking the temperature values
N O T E
The heater switches on and off automatically in
order to maintain the set temperature.
A light in the glass bulb indicates that the heater
is functioning.
The light and heater are switched off when the
set temperature is reached.
How to proceed:
• When the unit has been operating for about
one day, check the water temperature with
the supplied thermometer.
• The measured temperature is lower than the
set temperature:
Check the water flow
around the unit and, if necessary, move the
unit to a different position where the water
circulation is not obstructed by e.g. plants
• Measure the temperature again after some
time.
•
The temperature difference is still too great:
Set a slightly higher temperature on the unit.
• Measure the temperature again after some
time.
•
Change the setting again if necessary.