- EN -
18
biOrb Heater Set
•
Only operate with water at a water tempera-
ture of +4 °C to +35 °C.
INSTALLATION AND CONNECTION
N O T E
•
Ensure that the heater is immersed in water
at least up to the minimum immersion depth
marking.
•
The heater can be completely immersed in
water.
•
It is important to use the supplied holder for
fitting the heater. Ensure that the heater does
not make contact with the acrylic wall of the
aquarium.
N O T E
The desired water temperature can only be
achieved if the heating capacity of the heater is
suitable for the volume of water in the aquar-
ium (
→
Technical data) and is positioned in an
area with good water circulation.
How to proceed:
B, C, D, E
•
Turn the temperature controller to the de-
sired temperature value.
•
Select one of the options for fastening the
holder in the aquarium.
•
Insert the supplied suction cups into the
holder by twisting.
–
Pay attention to the alignment of the tabs
(they should point upwards or to the side).
•
Clamp the holder to the unit.
•
Position the unit with the heating element
pointing towards the floor of the filled aquar-
ium on a clean, smooth surface in an area
with good water circulation.
•
Fit the thermometer opposite the heater at
approximately the same height.
COMMISSIONING/START-UP
C A U T I O N
Risk of injury from hot surface!
Risk of burning parts of the body or risk of fire.
•
Disconnect the heater from the mains and al-
low it to cool down before commencing any
work.
Содержание Biorb 46000
