Oase AquaMax Eco Premium 12000 12V, Руководство по эксплуатации

Страница: 14 / 140

- EN -
14
Maintenance and cleaning
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Cleaning the unit
N O T E
Recommendation regarding cleaning:
• Clean the unit as required but at least twice a year.
• When cleaning the pump, pay particular attention to the cleaning of the impeller unit and pump housing.
• Do not use aggressive cleaning agents or chemical solutions as they could attack the housing or impair the function
of the unit.
• Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent PumpClean from OASE.
– Vinegar- and chlorine-free household cleaning agent.
• After cleaning, thoroughly rinse all parts in clean water.
Cleaning the pump

E, G
Remove hoses from the unit. Open the clips (3) and remove the strainer top casing.
Rele ase the clamp (4) and take pump out of the bottom strainer casing. Pull suction adapter (5) and regulator (6) from
the pump.
AquaMax Eco Premium 6000 12 V:
• Vigurously turn the pump housing counter- clockwise (bayonet lock) and remove.
• Clean the pump housing, O ring and impeller under clean water using a brush.
• Check parts for damage and replace, if necessary.
• Reassemble in the reverse order.
AquaMax Eco Premium 12000 12 V:
• Remove screws and the pump housing.
• Clean the pump housing, impeller and flat seal under clean water using a brush.
• Check parts for damage and replace, if necessary.
• Reassemble in the reverse order.
S Malfunction
Malfunction Cause Remedy
The unit does not perform its suction function No mains voltage
Impeller blocked/running dry
Check mains voltage
Clean/check supply lines
Water flow insufficient Strainer casing/satellite filter clogged
Hose blocked
Hose kinked
Excessive loss in the hose due to friction
Clean
Clean, or replace, if necessary
Check hose, and replace, if necessary
Reduce hose length to reduce frictional loss
Unit switches off after a short running period Strainer casing clogged
Unit running dry
Clean
Check supply line