Oase 56929, Руководство по эксплуатации

Страница: 4 / 20

4
- English -
Installation
1.
Lay the outlet pipe for the water outlet into the pond and
the hose for the sludge drain into the sewage system or
flower bed with a sufficient gravity (i.e. slightly downhill).
2. Place the unit at a flood protected position at a distance
from the pond edge of at least 6.6 ft (2 m) on a firm and
level ground.
○ Ensure unrestricted access to the cover to be able to
carry out work on the unit.
3. To avoid pressure loss, use hose connections which are as
short as possible and have a maximum internal diameter;
avoid bends and lay well protected.
○ Saw off the open stepped hose nozzle at the
corresponding mark.
● Push or turn the hose for the water inlet onto the open stepped
hose nozzle and secure with a hose clip.
● Place a flat sealing ring on the thread of the stepped hose
nozzle, push the thread of the stepped hose nozzle through the
water inlet, insert an O ring on the thread from inside, screw the
inlet nozzle on the stepped hose nozzle from inside ensuring that
the opening points downward.
● Close the second water inlet with the closed hose nozzle (except
when fitting an OASE UVC pre-clearing unit, e.g. Bitron).
●
Lay the hose so that it cannot be stepped on, avoid kinks and
connect it to the pump.
● During normal filter operation, the sludge drain should be closed
using the cover cap.
● To permanently fit a 2” hose to the sludge drain, unscrew the
cover cap from the dirt drain, push the union nut over the 2” hoze
nozzle, push on the hose and secure with the hose clip, insert
the flat sealing ring in the union nut and firmly screw-tighten the
2” hose nozzle including the union nut on the dirt drain.
● As an option, you can permanently fit a 1/2” connection for a
garden hose to the fresh water connection and to connect the
OASE pond aerator AQUAOXY 400 to the air connection to
ensure an adequate oxygen supply to the pond.
1.
2.
3.