13
CARE & CLEANING
• Battery Care
• Care of the Steel Base and Wood Trim
DIRECTIONS FOR USE
CARE & CLEANING
• Battery Care
HOW TO CARE FOR YOUR
Marina
™
BATTERY:
In order to maintain the quality and ensure the life of the
Marina
™
, here
are some preventative steps that can be taken to protect the battery..
• The charger must be used in a dry environment
• Normal use of the lift function of the table is a 10% duty cycle
(i.e. 2 minutes of continuous use followed by 18 minutes off)
The recommended battery recharge interval for the
Marina
™
table is every 3 hours of normal use. At this rate the battery
should last for 1200 recharge cycles or 3600 usage hours.
• The battery shold be recharged when the level indicator on the
control box is at 75% (before it drops to 50%). In this way, maximum
battery life may be achieved. If used every day in this manner, a
battery should last up to two (2) years.
• It is recommended the battery be fully charged before first use
after receiving the table new. Charging time is 4 hours.
• It is recommended that the battery be left to charge over periods
of non-use and that only a freshly charged battery be used after
periods of non-use. Non-use is defined as overnight or over a
weekend.
• DO NOT fully discharge the battery before recharging. Use of
the battery in this way will shorten the recharge cycles to that of
approximately 180 recharge cycles and thus shorten the life of
the battery.
You can receive the most from the battery on your
Marina
™
by following these
easy recommendations and care instructions.
HOW TO CARE FOR YOUR
Marina
™
SUPPORT FRAME:
The
Marina
™
base is made of a durable steel frame with a high quality
powder-coated finish and teak accent trim. Since all steel products can
rust if not properly protected, it is important that any damage or scratches
to the powder-coated finish be repaired as soon as possible. The steel
frame should be inspected frequently. If any damage is noted, a touch-up
paint bottle can be obtained from OAKWORKS
®
Customer Service at
1.800.558.8850
•
Use only a mild solution of 4:1 diluted non-alcohol cleaner such
as 409
®
, Fantastik
®
or some other non-abrasive cleaner to wipe
down the metal and wooden surfaces. Apply with a damp (not
wet) lint-free cloth. Be sure excess liquid does not drip onto, or
into, any of the electrical controls or mechanisms. Wipe these
areas carefully with a lint free cloth.
• Steel Base
& Wood Trim
4
INST
ALLA
TION
INSTALLATION
INSTALLATION
• Leveling Instructions
The
Marina
™
comes completely assembled and ready to use. Be sure to
charge the battery for 4 hours prior to use.
Arrange the control cords so that they will not create a tripping hazard. Place
the controls in a safe location where they are convenient and accessible.
Keep the controls out of the way of all table mechanisms.
L E V E L I N G I N S T R U C T I O N S :
If Table Will Not Sit Flat on the Floor:
The
Marina
™
is equipped with Leveler Feet that adjust to level the table
on uneven floors. Adjust each leg individually by turning the foot clockwise
or counter-clockwise to adjust height of each leveler foot until the unit
rests level and steady. This adjustment will not effect the function of the
table.
Leveler Foot
CAUTION
The table weighs as much
as 225 lbs.
DO NOT
lift or
move the unit without using
proper safely procedures
or equipment.
DO NOT
turn
the
Marina
™
on its side for
any reason. To do so could
cause damage to the base
and
will
void the warranty.
There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT
• Leveling Feet
When operating the
Marina
™
controls be
sure to observe all cautions
and warnings given in the
manual to prevent injury to
both operator and client.
Clockwise or counter-clockwise
depending to level table
