SETTING UP YOUR DEVICES
For 600 series devices
:
PCD 650, PC 650 & PD 650
CD 650, pH 620, 610 & 600
COND 610, 600 & DO 600
In order to start printing on your Microprinter, you must first configure your
device to be compatible with it. Please follow these steps:
1)
Turn your device on.
2)
With the
e
or
f
arrows, shift the bar till you see SETP on the
screen and select it using the corresponding “F” button.
3)
Then press ENTER to proceed.
4)
You will see the word SYSTEM. Press ENTER again to select it.
5)
Using the correct “F” button, select NEXT-P three times until you
reach SYSTEM –PAGE 4.
6)
At this page, select PRINT MODE and change IrDA to LED by
using the
c
or
d
arrows.
7)
Then hit ENTER to move one step down to DATA FORMAT.
8)
If you’re printing on a PC with the Hyperterminal* software or on
the microprinter, change the format to TEXT using the
c
or
d
arrows.
9)
Hit F4 to exit.
10)
Face the device’s infrared window (usually on the left side of
device) directly to the RS232 Adapter’s infrared window. *Do Not
Move These Positions During Printing.
11)
To print, simply use the
e
or
f
arrows to scroll until you see
PRIN.
12)
Turn on your microprinter and select PRIN using the correct “F”
button.
NOTE
: Before printing, please refer to manual for microprinter to configure
it with a BAUD rate of 2400 BAUD, 8 data bits, parity = none, stop bits =1.
*This adapter only works on Hyperterminal and
NOT
Cybercomm software.
3
