Oak Telecom VoxBox, Руководство пользователя

Страница: 44 / 165

DTMF Programming
The system administrator can set the notification method to one of two states
(code *760):
Notification on first new message
Notification on every new message
Sign Rings . The unit rings the notified extension number. These Sign Rings
may be sent at programmed intervals (code *720). The unit stops sending Sign
Rings after the mailbox owner retrieves all his new messages or the maximum
number of retries has been made (code *750).
Rings . The unit rings the notified extension for a programmed time period
(code *730). When the mailbox owner answers, the unit prompts him to enter
his password. After entering the password, the mailbox owner may retrieve
his messages. If the mailbox owner does not answer, the unit tries again at
programmed intervals (code *720). The unit stops sending Ring notifications
after the mailbox owner retrieves all his new messages or the maximum
number of retries has been made (code *750).
4.4.3.2 Remote Notification
The mailbox owner may choose to be notified at a remote location (i.e. his
mobile telephone, home telephone or pager) by entering a remote telephone
number (of up to 20 digits) or pager number (of up to 40 digits). You can use any
combination of *, #, A-D, 0-9, and Pause when setting the remote notification
telephone number.
After remote notification is enabled, the unit will dial the remote phone or pager
number and notify the mailbox owner of any new messages. After entering the
password, the mailbox owner can retrieve his messages. The duration of remote
notification rings is programmed using code *730.
The unit stops sending Ring notifications after the mailbox owner retrieves all his
new messages or the maximum number of retries has been made (code *750).
The mailbox owner must obtain permission from the System Administrator to
enable remote notification. The System Administrator must use code *710 or
*711 to grant permission.
The remote notification activation time can be programmed so the administrator
can decide on the daylights hours for the external notification to be activated. The
time span of this service is programmed using code *490.
When permission has been granted and the mailbox owner enables remote
notification, the unit first dials the external access digits (programmed using code
*340) and then dials the mailbox owner’s remote telephone or pager number.
NOTE
Make sure that you enter the remote telephone or pager number before enabling remote
notification.
Notification is always done on the second line.
Voice Mail and Auto Attendant System Installation and Programming Manual 4-14