Page 4 Copyright © 2011 Kel Technologies - All Rights Reserved
Installation:
Place the Quick Install Guide on the wall in the desired location to determine the
spacing and placement of the mounting holes on the wall. A carpenters level
should be used to insure that the O3 Pure LS is mounted level in the horizontal
plane. (
Fig. c
)
Mark the location of the two mounting holes on the wall with a pencil. Drill appro-
priate sized holes for the screws or molly’s in each marked location. Install the
screws leaving them protruding from the wall by about 1/4 inch. It is recommended
that the mounting whole on the right side of the O3 Pure LS (above the water inlet/
outlet) be mounted to a wall stud, if possible. A set of mounting hardware (screws
and molly's) have been provided. If it is not possible to mount the O3 Pure LS to
wall studs, you should use the "molly" type expandable screw anchors. For any
other type of mounting scenario (concrete block, etc.) please consult your local
hardware store for assistance.
Remove the cover from your O3 Pure LS by pressing the tabs on each side of the
cover inwards. (
Fig. d - d.1
) While holding the tabs in, lift the cover up 1 inch (2.54
centimeter’s) and then straight out toward you.
Place the O3 Pure LS against the wall so that the protruding screws slip through
the “keyholes" (
Fig. e - e.1
) in the back of the unit. Gently slide the unit down into
the lock position of the keyholes. You can now tighten the two screws to hold the
unit firmly in place. DO NOT over tighten the screws, as it may cause damage to
the back panel of the unit.
Turn off the hot and
cold water
taps/faucets to your washing machine. Place a
pail under the
cold water
hose connection to the washing machine. Disconnect
the cold hose from the washing machine placing the end into the pail. Flush
cold
water
line with ½ gallon (2 litres) of water by turning the
cold water
tap on. Check
filter (if applicable) at the
cold water
inlet of washing machine. Clean residue from
filter if necessary. Check that the rubber washer in the hose is in place and con-
nect the
cold water
hose from the
cold water
supply to the inlet supply of the O3
Pure LS (
Fig. f - f.2
). Properly tighten the hose to the inlet fitting, but do not over
tighten.
Using the new hose provided connect one end of the hose to the water outlet of
the O3 Pure LS and the other end of the hose to the
cold water
inlet of the
washing machine (
Fig. f - f.1
) Properly tighten both ends of the hose,
but do not over tighten.
Replace the cover on the O3 Pure LS.
Plug the power adaptor into the DC adaptor plug-in on the side of the O3 Pure LS
unit (
d.2
) and then plug the adopter into the wall outlet. (
Fig. b
)
Ensure all hoses are properly installed and tightened, and that the power supply
has been securely plugged in. SLOWLY turn the COLD water supply back on and
check for any leaks or drips. Gently re-tighten fittings if leaks are apparent, Be
careful not to over tighten.
Set the wash cycle on your washing machine to
COLD WATER
wash and
COLD
WATER
rinse.
