8
MANUFACTURER’S USE ONLY
Quality
Check
Date:____________
Orifice # (MAIN)
____________
Model #
____________
Orifice # (OTHER)
____________
Serial #
____________
Leak
Test:
____________ Air
Shutter:
____________
Burn
Test:
____________ Inspector:
____________
Gas Type:
NAT / LP
CONVERTING YOUR FIRE PIT TO A DIFFERENT GAS TYPE
(OR TO CONVERT FOR HIGH ALTITUDE*)
To convert your Fire Pit from propane to natural gas or natural gas to propane gas, carefully follow the steps below:
(
Conversion Kit with proper orifice to convert burner to natural gas is included in instruction packet
.)
1.
MAKE SURE THAT THE GAS SUPPLY TO THE FIRE PIT (AND ANY NEARBY ELECTRICAL
SOURCES/APPLIANCES) ARE SHUT OFF.
2.
Carefully detach the connector hose attached to the orifice holder (Figure # 1) and unscrew the orifice holder
from the burner pipe (Figures #1 and # 2).
3.
Remove the orifice from the holder (Figure # 2 ) and replace it with the proper sized one for your gas
requirement. Propane requires the smaller orifice.
4.
If you are converting to propane (LP) gas, slide the air shutter so that the air intake hole is open (Figure #1). For
natural gas, slide the air shutter so that the air intake hole is closed (Figure #2).
5.
IT IS NECESSARY TO ATTACH THE LABEL OR RATING PLATE INCLUDED WITH THE CONVERSION KIT
TO CLEARLY INDICATE THE FIELD CONVERSION.
Air intake hole open for
LP Gas
Open air
shutter
Orifice holder
Connector hose
Air shutter closed for
Natural Gas
Connector hose
Orifice holder
Orifice
Burner
Figure 1
Figure 2
For installations above 2,000 feet,
contact your local dealer or gas supplier
before installing as input ratings will be
reduced approximately 4% for each
1,000 feet above sea level. Refer to the
National Fuel Gas Code.
*
High Altitude Conversion Kit
Contact your distributor to obtain a High
Altitude Conversion Kit. Conversion kit
includes the proper orifice, conversion
diagram and conversion label.
Follow steps 1 – 5 shown above.
THE CONVERSION SHALL BE
CARRIED OUT BY A
MANUFACTURER’S AUTHORIZED
REPRESENTATIVE, IN ACCORDANCE
WITH THE REQUIREMENTS OF THE
MANUFACTURER, PROVENCIAL OR
TERRITORIAL AUTHORITIES HAVING
JURISDICTION AND IN ACCORDANCE
WITH THE REQUIREMENTS OF THE
CAN/CGA-B149.1 OR CAN/CGA-B149.2
INSTALLATION CODES.
After conversion follow Operating
Instructions found on Page 7.
