NXP Semiconductors
S32K3X4EVB-Q172 HWUM
S32K3X4EVB-Q172 | S32K3X4EVB-S172 - Hardware User Manual
S32K344EVB-Q172 | -S172 HWUM
All Information provided in this document is subject to legal disclaimers
© NXP B.V. 2020. All rights reserved
NXP Semiconductors
REV A
– 10/2021
Page
8
of
31
4. When power
is applied to the EVB, three orange LED’s adjacent to the voltage regulators show the presence of the supply
voltages as follows:
•
LED D2
Indicates that the 12.0V is connected to the EVB correctly.
•
LED D4
Indicates that the 5.0V linear regulator is enabled and working correctly.
•
LED D5
Indicates that the +3.3Vlinear regulator is enabled and working correctly.
Figure 3. S32K3X4EVB-Q172 | -S172
– Power supply Input and LED power indicators
If no LED’s are illuminated when power is applied to the EVB and the regulators are correctly enabled using the appropriate
jumpers, it is possible that either power supply is not connected properly, or the voltage level is lower that the specified [+12.0V
to
≥2Amps].
Note that the fuse will not protect against one of the EVB regulators being shorted. If this happens, damage is likely to occur to
the EVB and / or components.
5. The board is ready to use now.
7 S32K3X4EVB-Q172 | -S172 - Power supply
The EVB requires an external power supply voltage of between to +12V/
≥2A. This allows the EVB to be easily used in a
vehicle if required. The 12v input is on the EVB is used to supply a FS26/SBC
– U1, the power management IC controller
pr5.0V, +3.3V and +1.5V, for the different power configurations of VDD_HV_A, VDD_HV_B, V15 and other
interfaces