BL ID
Hardware Manual
Project Name: Integration Manual Project ID: 62743
4. INSTALLING MANUAL
4.1.
Desktop use
Customer Evaluation Board PNEV5180B is intended for development use in development
environment such are development departements in factories, at institutes. PNEV5180B
board is powered via USB serial connection from personal computer or via external power
supply.
Usuall climate conditions in development environment (room temperature and humidity) are
deep inside Customer Evaluation Board PNEV5180B specified climate conditions.
4.2.
Power supply
Customer Development Board PNEV5180B has no power supply mounted on pcb. There are
two possibilties to connect external power supply:
- powering via USB port (mini B or micro B connector) from personal computer or
- via external power supply 7,5 V DC / 500 mA.
Which option is used is set with jumper J4 (figure 17).
The mini B USB (or micro B USB) connector is used for connection to the PC usb port – for
power supply and USB serial communication. Used this power option is default setting with
jumper J4. USB A male to mini (micro) B USB (5 pin) cable is used for connection between
Customer Evaluation Board PNEV5180B and personal computer.
External power supply 7.5 V DC / 500 mA is connected to power jack X4 to supply Customer
Development Board PNEV5180B. On board IC LT1129IST-5 is used to stabilize voltage to 5
V.
Note 1:
Power supply from USB port on personal computer has to comply with LPS requirement of
IEC60950-1.
Maximum lenght for USB cable is 1.8 meter.
Note 2:
External power supply 7,5 V DC / 500 mA has to comply with LPS requirement of IEC60950-
1.
Maximum lenght for power cable is 1.8 meter.
STS Template 1.0
public
© NXP B.V. 2015. All rights reserved
Doc ID: DOC-XXXXXX
Doc Rev 1.00 Preliminary — 2015.11.13
12 of 16