NXP Semiconductors PCA9617ADP-ARD, Руководство пользователя, Страница: 18 / 25

NXP Semiconductors
UM11763
PCA9617ADP-ARD user manual
To operate the setup, along with the EVK and the daughterboard, a third board must be
included in the setup assembly. Figure 9 shows the necessary boards and how these
boards are connected. The configuration consists of:
• One i.MX 8M Mini LPDDR4 EVK board
•
One PCA9617ADP-ARD daughterboard
• One IMX8MMINI-IARD interposer board
• One USB-A/USB-C cable
• One USB-A/USB Micro-B cable
•
A PC with Windows 10 operating system
It is recommended to attach the PCA9617ADP-ARD to the Arduino connectors of the
IMX8MMINI-IARD interposer board first, and then the resulting assembly to the i.MX 8M
Mini LPDDR4 EVK. This can be done by plugging J1 connector located on the interposer
board to J1003 connector on the EVK.
To power up the EVK, a USB-C cable connected to port 2 of the EVK is used. The power
switch SW101 on the EVK board must be set to ON position to power up the setup. Data
communication is achieved by routing a separate USB (Micro-B) cable from a USB port
on the PC to the debug port (J901) on the EVK (see Figure 9 and Figure 10 ).
The user may find details regarding power up and operation of the setup assembly in
8MMINILPDDR4-EVK User Manual and IMX8MMINI-IARD User Manual. The files can be
downloaded from www.nxp.com/ .
Figure 9. The assembly PCA9617ADP-ARD daughterboard, IMX8MMINI-IARD interposer board, and i.MX 8M Mini
LPDDR4 EVK, before starting
To configure and operate the setup, follow the below steps:
1. Insert the PCA9617ADP-ARD onto the IMX8MMINI-IARD interposer board Arduino
connectors (located on the top side);
UM11763 All information provided in this document is subject to legal disclaimers. © 2022 NXP B.V. All rights reserved.
User manual Rev. 1.0 — 22 July 2022
18 / 25