Specifications
MIMXRT1064 EVK Board Hardware User’s Guide, User's Guide, Rev. 0, 10/2018
14
NXP Semiconductors
•
Reset RED LED(D21)
•
OpenSDA LED(D20)
•
USER LED(D18)
2.22. LCD interface
The enhanced Liquid Crystal Display Interface (eLCDIF) is a general purpose display controller.
The eLCDIF block supports the following:
•
Displays that support moving pictures and require the RGB interface mode (DOTCLK interface).
The eLCDIF provides fully programmable functionality to supported interfaces:
•
Bus master interface to source frame buffer data for display refresh.
•
8/16/18/24/32 -bit LCD data bus support available depending on I/O mux options.
•
Programmable timing and parameters for DOTCLK LCD interfaces.
If developers want to use LCD, NXP provides an optional LCD module RK043FN02H-CT which has a
4.3 inches touch-screen and supports a resolution of up to 480*3(RGB)*272. This module contains two
FPC cables. The LCD interface can be connected to J8(A1-A40) and the CPT interface can be connected
to J8(B1-B6). LCD modules can be purchased from the NXP website.
3. PCB information
The MIMXRT1064 EVK Board is made using standard 4-layer technology. The material used was FR-
4. The PCB stack-up information is shown in
Table 7
.
Table 7.
Board stack-up information
Layer
Description
Copper(Oz)
Dielectric
Thickness(mil)
1
Signal
1
—
Dielectric
—
3
2
GND
1
—
Dielectric
—
52
3
Power
1
—
Dielectric
—
3
4
Signal
1
—
4. EVK design files
The schematics, layout files, and gerber files (including Silkscreen) can be downloaded from
nxp.com/MIMXRT1064-EVK
.