Quick Start Guide
8
8
SETTING UP THE SYSTEM
1
Insert MicroSD
Card
Insert the MicroSD card into socket J301
on the CPU board (700-28617).
2
Connect USB
Debug Cable
Connect the micro-B end of the supplied
USB cable into debug port J1901 on the
base board (700-28616). Connect the
other end of the cable to a PC acting
as a host terminal. If needed, the serial
to USB drivers can be found at
www.silabs.com/products/mcu/Pages/
USBtoUARTBridgeVCPDrivers.aspx
Open the terminal window (i.e., Hyper
Terminal or TeraTerm) and apply the
following configuration:
• Baud rate: 115200
• Data bits: 8
• Stop bit: 1
• Parity: None
• Flow control: None
3
Connect LCD Module
(optional)
Connect the FPC cable of LCD Module
(LCD8000-43T) to the LCD connector
J901 on base board (700-28616), which is
bottom contact.
Note: The LCD Module is not included in the kit. It is sold
separately at www.nxp.com/iMX6ULEVK.
4
Connect Ethernet Cable
(Optional)
Connect an Ethernet cable to the right
port of the Ethernet Jack J1501 (close to
the HDMI connector).
5
Connect Power
Supply
Connect the plug of the 5 V power
supply to the DC power jack J2001 on
base board (700-28616) and slide power
switch SW2001 to ON. When power is
connected to the EVK, it will automatically
begin the boot sequence.