KIT34704BEPEVBE Evaluation Board
, Rev 1.0
Freescale Semiconductor
14
KITUSBI2CEVME - Using Hardware
10.1.2 J8
This jumper is to enable the status indicator LED. The LED is ON when any operation
is being performed by the MCU.
Figure 9. JB8 Status Indicator
10.1.3 J1
The J1 jumper should be disconnected only while JB8 is being programmed. Since the
MCU is already programmed, J1 should be connected all the time, so the board
operates properly. It is not recommended to program the JB8 due to pre loaded program
will be erased and it will not longer operate correctly.
Figure 10. Crystal Circuitry
