NXP Semiconductors
AN12397
EdgeLock
TM
SE050 Quick start guide with i.MX6UltraLite
AN12397
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2019. All rights reserved.
Application note
Rev. 1.2 — 17 December 2019
534512
7 / 21
Figure 4. Plug the power supply and connect the USB cable to your laptop
2. Download the
USB to UART Bridge VCOM driver
for your processor (either 32 or 64
bits). Install the driver by following the setup wizard until it is finished.
3. Unplug and plug your board.
4. Go to your Device Manager, and check that your board is recognized and assigned
to a port number (COMxx). Write down the assigned port number (COMxx) as it is
needed in the next steps. Your Device Manager should look like
