NXP Semiconductors i.MX 6SLL, Быстрый старт, Страница: 6 / 12

Quick Start Guide
6
SETTING UP THE BOARD
1
Insert SD
Card
Insert the supplied SD card into the SD1
card slot.
2
Set Up
Boot Switches
By default, boot switches are configured
to boot from SD1. If any other boot
source is desired, boot switches have to
be configured according to Table 1.
3
Connect USB to
UART Cable
Connect from USB to UART port (J26)
using a micro USB cable to PC. Once the
PC recognizes the virtual USB to UART
device, it can be seen it in your PC Device
Manager list.
Serial port configuration: 115.2 Kbaud, 8
data bits, 1 stop bit, no parity.
Note: The PC needs a driver to enable
a virtual COM port through the PC USB
port.
Visit
ftdichip.com/drivers/vcp.htm
to
download the correct driver.
4
Connect Parallel
Display
LCD daughter card MCIMX28LCD, which
has to be connected to J13. For more
information about this board, please visit
www.nxp.com
.
5
Connect Power
Display
Connect 5 V power supply into power jack
J6 and set SW14 to the On position.