Figure 2. Schematic diagram of hardware connection
Suggestions for users include:
• To prevent the debuggers or target being damaged, it is forbidden to plug or unplug the debugger while target is powered on.
The recommended sequence for powering on or off is as follow:
— Power on: debugger >target
— Power off: target >debugger
• The debugger interface has pin1. Please double check the direction to prevent damages to the debugger or target.
• It is recommended to press F1 to enter the on-line help system to get familiar with debugger.
1. Taking RT1064 EVK board as an example, the hardware connection is as shown in
.
a. Connect Lauterbach JTAG debugger to the EVK board by the 20pin JTAG interface.
b. Connect to the PC through the USB cable, and then power on the debugger with a 5 V power adapter.
c. Connect the EVK USB port to the PC.
NXP Semiconductors
Hardware connection diagram
Introduction to Boundary Scan of i.MX RT Series, Rev. 1, March 2, 2021
Application Note
4 / 15
