User Interface
BLDC Control Demo User's Guide, Rev. 6, 06/2020
20
NXP Semiconductors
•
Speed slider—sets the required speed.
•
DC-bus voltage gauge—shows the actual DC-bus voltage.
•
DC-bus current gauge—shows the actual DC-bus current.
•
DC-bus current limitation slider—sets up the DC-bus current limit.
•
Demo mode button—turns the demonstration mode on/off.
•
STOP button—stops the whole application.
•
Application State Notification—shows the actual application state and faults.
Figure 18. FreeMASTER control page
The MCAT tuning tool plug-in module is in the FreeMASTER GUI
.
This tool is targeted at
motor-control applications, where you can change the motor-control parameters or adjust the start-up
and control parameters. Each tab represents one submodule of the embedded-side control, and tunes its
parameters. For more information, see
Sensorless BLDC Control on Kinetis KV
Here are the basic instructions:
•
To start the motor, set up the required speed using the speed slider.
