1
5
2
3
6
10
8
11
7
12
9
4
13
14
15
16
17
REMOTE CONTROL QUICK REFERENCE
2
15
PROGRAMMING YOUR REMOTE
If you purchase a new TV or a new remote or your remote is not
working correctly, you may need to program the remote to work with
the gateway. Simply follow these instructions:
Step 1: Finding the Gateway ID.
•
Press the
WRENCH
(setup) button on the gateway cable box and
a gray screen will appear.
•
Using the arrows on the gateway move down to
REMOTE
CONTROL SETUP
and press
SELECT
(the circle with a ‘
√
’ in it)
on the gateway. Another gray screen will appear.
•
Press the
PPV
button on the remote.
•
Write down the 3-digit Gateway ID __________. (If there are fewer
than 3 digits add zeros to the beginning - e.g. 8 becomes 008).
•
Press
EXIT
(the square with an ‘x’ in it).
Step 2: Programming the Gateway ID.
•
Press and hold the ‘B’ button until the red light flashes.
•
Press 7-8-9.
•
Enter the 3-digit Gateway ID (the red light will flash and go off).
Step 3: Programming the Remote Control ID.
•
Press and hold the ‘A’ button until the red light flashes.
•
Press 7-8-9.
•
Enter the correct number from below
•
1 for TV1 (TV that is set to Channel 4)
•
2 for TV2 (TV that is set to Channel 7)
•
3 for TV3 (TV that is set to Channel 13)
Step 4: Programming the TV Code.
•
Press and hold the
MUTE
button until the red light flashes.
•
Press the green
POWER
button.
•
Pointing at the TV continue to press and release the
UP ARROW
slowly
until the TV powers off. The system is searching for the
correct TV code.
•
Once the TV powers off press the
SELECT
button.
NOTE:
If you press the
UP ARROW
too quickly you may pass the
code before you press select. If this happens repeat Step 4, but press
the
UP ARROW
slowly until the TV powers off.
