NANO100
Feb. 26, 2018
Page
4
of 18
Rev 1.00
NUT
INY
-S
DK
-N
A
NO
1
00
U
S
E
R
M
A
NUA
L
2
NUTINY-SDK-NANO100 INTRODUCTION
NuTiny-SDK-NANO100 uses the NANO100KE3BN as the target microcontroller. Figure 2-1 is
NuTiny-SDK-NANO100 for NANO100 series, the left portion is called NuTiny-EVB-NANO100 and
the right portion is Debug Adaptor called Nu-Link-Me.
NuTiny-EVB-NANO100 is similar to other development boards. Users can use it to develop and
verify applications to emulate the real behavior. The on board chip covers NANO100 series
features. The NuTiny-EVB-NANO100
can be a real system controller to design users’ target
systems.
The Nu-Link-Me is a Debug Adaptor. The Nu-Link-Me Debug Adaptor connects your PC's USB
port to your target system (via Serial Wired Debug Port) and allows you to program and debug
embedded programs on the target hardware. To use Nu-Link-Me Debug adaptor with IAR or Keil,
pleas
e refer to “Nuvoton NuMicro
®
IAR ICE driver user manual “or Nuvoton NuMicro
®
Keil ICE
driver user manual” in detail. These two documents will be stored in the local hard disk when the
user installs each driver.
VDD (JP2)
Reset Button
(SW1)
I/O LED
Power LED
Target Chip
ICE Controller USB Connector
(ICE J2)
ICE Controller
Extended Connector
(JP6, JP7)
GND (JP3)
Extended Connector
(JP5, JP1)
Figure 2-1 NuTiny-SDK-NANO100 (PCB Board)
