Before Use
•
Severe dehydration and excessive water loss may cause inaccurate results. If you believe you are suffering
from severe dehydration, consult your healthcare professional immediately.
•
Inaccurate results may occur in severely hypotensive individuals or patients who are in shock. Test results that
are lower than actual values may occur in individuals who are in a hyperglycemic-hyperosmolar state, with or
without ketosis. Critically ill patients should not be tested with blood glucose monitor.
•
If you think your blood glucose results are inconsistent with your feeling or symptoms which you are
experiencing, repeat the test first. If you have symptoms or continue to get similar results, follow the
treatment advice of your healthcare professional.
•
If you are experiencing symptoms that are inconsistent with your blood glucose test, and you have followed all
of the instructions provided in this Owner’s Manual, contact your healthcare professional immediately.
•
Use only fresh whole blood samples to test your blood glucose.
•
Do not use test strips that are expired or appear to be damaged as they may return inaccurate results.
•
The lancing device is for self-use only. Do not share or re-use lancets. Please refer to the Lancing Device
Manual for the detailed procedure.
Battery Installation
1.
Open the battery compartment at the back of device.
2.
Insert 2 AAA batteries according to the +/- markings.
3.
Re-attach the battery cover back, ensuring it clicks into place.
NOTE: When the low battery symbol appears on screen, turn off this device and follow the instructions above to replace batteries.
CAUTION: Never leave any low battery in the battery compartment as it may leak and cause damage to this device.
Setting the Monitor
Before using this device for the first time or if you change the battery, you should check and update these settings.
Make sure you complete the steps below and have your desired settings saved.
When the year flashing, press M
until the correct year appears. Press
S to confirm.
When the month flashing, press
M until the correct month
appears. Press S to confirm.
When the day flashing, Press M until
the correct day appears. Press S.
When the hour flashing, Press M until
the correct hour appears. Press S to
confirm.
When the minute flashing, Press
M until the correct minute
appears. Press S to confirm.
Press M to select the unit of
measurement.
The
unit
of
measurement will be preset to mg/dL
before being sold to the U.S.A. Press
S to confirm.
