Nuvo NV-T2SIR, Руководство по установке, Страница: 11 / 30

1 2 3
4 5 6
7 8 9
0 OK
AM FM
DAB
SAT
DISP
BAND
PWR A/B
PRE
T2 Tuner
NV-T2RC4
REMOTE CONTROL
TUNER
1
2
3
4
5
6
7
8
9
10
11
12
13
P
C
P
C
TUNE
NV-T2RC4 Remote Control
1. Power: The power button turns the selected Tuner on and off.
2. Tune Buttons: These buttons are the equivalent of using the Up and Down arrows on the front panel of the T2FAM to tune.
3. Band: This button toggles through the Tuner’s available broadcast bands.
4. Seek Up and Down: The seek buttons will tune to the next available station with the required signal strength for AM and
FM use. The signal threshold can be adjusted higher or lower using the T2G Configurator software (see
pg. 18), or through the T2SIR Options menu on the front panel (see pg. 10).
5. Preset Tune: These buttons step through the assigned presets. The T2SIR is capable of 5 banks of 20 presets.
6. Pre/Dir: The T2 allows up to 10 preset stations in each of up to 10 preset banks. This button scrolls through each of the
defined banks and then to direct tuning. In direct tuning, you can use the numeric buttons to access a specific
station frequency or XM channel number. Presets are selected by a single push of numeric button 0-9.
7. Pre: This button is used to establish a preset bank and preset number for the frequency being displayed on the selected
Tuner.
8.
Tuner A & B LED: This LED glows red when Tuner A is selected and green when Tuner B is selected. This LED glows only
momentarily when a button is pushed.
9. A/B: This button toggles between Tuner A and Tuner B operation.
10. Disp: This button functions only for North American satellite radio use.
11. Numeric Buttons: These buttons (0-9) are used to access a specific station frequency.
12. OK: This is a select button used for saving presets or entering an AM or FM frequency.
13. Source Buttons: These four buttons are a direct select for the tuning bands available through the T2 Tuners. Actual
functionality depends on the model Tuner being controlled.
6