EN
EN
If the spline nut
(3)
and
shift driver
(4)
markings are not
aligned, full overdrive will need to
be reset.
f
If the markings are not obvious,
full overdrive should result in
the hub/wheel rotating 1.8-2
times for ever
y 1 rotation of the
CVP sprocket.
Set the hub inter
face to the full
underdrive
(L)
position (note this
is opposite of nor
mal installation).
Reinstall the hub inter
face (angular
position is unimpor
tant), leaving
the RH Nut uninstalled.
f
The hub inter
face will be
used to shift the CVP into full
overdrive by hand in the
following steps.
5. SERVICE INSTRUCTIONS
5. SERVICE INSTRUCTIONS
15
16
Resetting CVP to Full Overdrive
The
NuVinci
N360 CVP is shipped
in full overdrive with an anti-shift
retainer installed (reference
Step
2.2
).
f
If the hub inter
face is incorrectly
installed, full ratio range of the
CVP may be unavailable, and
full overdrive will need to be
reset.
If installed on the bicycle, shift
the CVP into overdrive
(H)
as far
as possible, and remove the rear
wheel per
Section 3
.
Remove the RH Nut
(2)
that
secures the hub inter
face
(3)
, then
remove the hub inter
face by lifting
carefully from under
neath.
H
2
3
5.
5
5.
5
5.
6
5.
7
4
3
5.
6
5.
7
L
