EN
EN
2. ASSEMBL
Y OF COMPONENTS
2. ASSEMBL
Y OF COMPONENTS
Installing Shift Cables and
Hardware
Pass the shift cables through the
appropriate cable housing and
ensure the housing is seated
completely into the shifter
.
f
Thread both barrel adjusters
completely clockwise (in) to
provide maximum installation
slack.
Pull the underdrive shift cable
(1)
fir
mly at the rear axle location
until it stops, checking to make
sure that the
NuVinci
shift indica-
tor
(2)
goes completely flat.
Pass the underdrive shift cable
(3)
through the UD cable stop
(4)
and secure the UD cable stop at
the distance shown while pulling
the cable fir
mly
.
f
Ensure that the cable housing
is seated fully at the shifter
.
f
Using a 2mm allen, secure the
cable and torque to 1.5-2.0
Nm
(
13-18 in-lbs
)
.
f
Cut the excess cable at a
maximum of 2.0mm from the
end of the UD cable stop
(5)
.
Pull the overdrive shift
cable
(6)
fir
mly at the hub inter
face
until it stops, checking to make
sure that the
NuVinci
shift
indicator goes into a steep hill
(7)
.
f
Make sure the underdrive shift
cable and UD cable stop are
free and unobstructed.
Pass the overdrive shift
cable
(8)
through the OD latch
(9)
and secure the OD latch at the
distance shown while pulling the
cable fir
mly
.
f
Ensure that the cable housing
is seated fully at the shifter
.
f
Using a 2mm allen, secure the
cable and torque to 1.5-2.0
Nm
(
13-18 in-lbs
)
.
f
Cut the excess cable at a the
OD latch marking
(10)
, and
tuck the remaining cable length
into the OD latch as shown
(11)
.
The cable hardware should
appear as shown. Assemble to
CVP per
Step 3.2
and adjust cable
slack with barrel adjusters per
Step 4.2
.
9
10
2
.15
2
.16
2
.17
2
.18
2
.19
1
2
3
4
5
120mm
2
.15
2
.16
7
6
2
.17
8
9
10
11
111mm
2
.18
2
.19
