background image

www.NutriChefKitchen.com

    Wait for 2 mins, then pull on the pressure relieving ring  
    for a couple of seconds. This is for adjusting pressure of  
    keg beer.
5. Put a glass or pitcher under 
     the faucet spout, with the
     faucet knob pulled forward 
     (ON), slowly turn the regulator 
     knob on in clockwise direction, 
     until beer starts to flow out.
     Don’t continue adding 
     pressure, suggest tapping 5-8
     PSI (Max pressure 30 PSI), so 
     please stop turning the regulator knob when the   
     pressure is  enough to tap beer out with perfect foam.  
     Too much pressure would cause over foam. When the  
     beer stopped or flow slower, try turning the regulator  
     knob on slowly, to get bigger pressure.
6. When you finish tapping, please turn regulator knob to  
    OFF position.
7. If there is no beer flowing out, then the CO2 capsule  
    needs to be replaced, unless no beer is remained   
    (Normally, 16g capsule can tap 4-5 liters of beer).

  

Caution:

 Removing a punctured capsule from regulator 

should be done slowly. Swish is expected if pressure 
remains.

8. Turn the regulator knob off and install a new capsule  
    into the regulator by following above steps.

TROUBLE SHOOTING GUIDE

1. Faucet Leakage

     Solution:

 Screw out and remove the faucet, then install  

     

again, make sure the faucet can match the connection  

     

of spear tightly.

   35x3.1 MM (1pcs)

   13x10x2 MM (1pcs)

C  

   8x1.5 MM. (1pcs)

D

    11x1.5 MM (2pcs)

E

     8x2.5 MM (3pcs)

       (Out Diamter* Thickness)

O RING ASSEMBLY:

2. Too much Foam

    Solution:

 Decrease the pressure properly.

3. Leakage of  CO2

     CO2 capsule should be installed properly and tightly.

In case there is CO2 leakage, please observe the position 
of leakage and continue with the tightening process, but 
never screw out if gas remains.  

PART FOUR: 

WARNING

1. Keep away from children under 18.
2. Never point cylinder towards someone’s face.
3. Do not heat over140°F as rupture may occur!
4. Discontinue using of this equipment if unsolvable  
    leakage or visible damage is found.
5. Capsule end become punctured when turned into  
    regulator base. Unscrewing before it’s empty can result  
    in loss of high pressure gas. Please remember, never  
    unscrew the CO2 capsule before gas used up, liquid CO2  
    spray onto unprotected skin may cause freezing burns.
6. Exterior of capsule may become frozen when in use,  
    this is normal. But don’t touch with bare hands, your  
    fingers could stick to the frozen surface and cause  
    frostbite.
7. Please ship via land or sea shipment, never bring CO2  
    capsule when you travel by air.

O RING INFORMATION:

Questions? Issues?

We are here to help!

Phone: 

(1) 718-535-1800

Email: 

[email protected]

This product can expose you to a chemical or group of chemicals, which 

may include 

”Chromium”

 

which is known in the state of California to cause 

cancer, birth defects, or other reproductive harm. For more info, go to 

https://www.p65warnings.ca.gov/

.

A

E

B

D

C

Отзывы: