Step 7
Once ice making cycle is finished, the water tray will tilt forward; the remaining water flows back to the
water reservoir and the ice cubes will drop from the fingers.
Step 8
In about 15-35 seconds, the water tray will tilt backward, ice in produced in previous cycle will be pushed
to ice reservoir directly, unit back to work from step 4 to step 6 again
Step 9
Push the ice cube dispenser puncher button(sketch 6) to get ice, the indicator
will be on
Note: Please put your cup below the ice cube dispenser shoot directly.
Notice: If the ice is stored in the unit for long time, the ice may freeze and stick together, then no ice will
be
dispensed even the ice is full, if so, please kindly use scoop included in the unit to break the ice
first, then push the puncher button.
Step 10
Press ON/OFF button to stop the unit
Step 11( for ZB-10B only)
When you push the WATER button, you can get water
Note: if you need to get cold water, at least the ice making function should be turn on.
Please make sure your cup is below the cold water outlet, or water will be splashed every where
Caring
1.Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When
cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to
clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2.Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
3.If the icemaker is reused after a long time, the water pump may not pump sufficient water due to an air
block, the deficient water indicator turns on in this case . To correct this press the START button again,
then the icemaker will work normally.
4.To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24
hours.
5.If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not
start the system right away, wait 3 minutes, and then re-start the Ice maker.
6.Always use fresh water before starting ice production either at initial installation or after a long shut-off
period.
7.This unit is for home use only, not for outdoor use, if it is necessary for use outside, please make sure
the view window is closed.
