Page 4
ALLURE
®
WS3 SERIES
RANGE HOOD
PREPARE THE HOOD
13
3¼” x 10” Ducted Discharge Only: Remove
Tape
from damper
flap and attach
Damper/Duct Connector
over knockout
opening with screws removed in Step 4 under “PREPARE
THE HOOD”. Make sure damper
Pivot
is nearest to
Top/Back
Edge
of hood.
DAMPER/
DUCT
CONNECTOR
(Vertical
discharge
position shown)
TAPE
UP TO 1”
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
TOP/BACK
EDGE
NOTE
Damper/Duct Connector can be installed up to 1-inch
on either side of hood center - to accomodate off-center
ductwork. In extreme off-center installations, one end of
the duct connector may need to be trimmed to clear the
electrical cable clamp.
PREPARE THE HOOD
11 Remove
appropriate
Duct Knockout(s)
from top or back of
hood.
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼” x 10”
Horizontal Discharge)
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼” x 10”
Vertical
12
Horizontal Discharge Only: Remove the
Plate
in front of the
horizontal discharge knockout. Cut the
Ties
, lift plate out,
and discard plate. DO NOT REMOVE the
Metal Strip
held
in place with two
Screws
.
TIES
PLATE
METAL STRIP
SCREW
10
Non-Ducted Installations Only: Require a
Performance Ring
to be attached to the blower wheel.
To install ring:
1.
Remove
the
Blower Wheel
by rocking it side to side and
applying a slight force to pull wheel from motor. Remove
Retaining
Ring
if necessary.
2. Slide the ring onto the
Small Diameter End
of the wheel
and down to the
Stop Edge
of the wheel.
3. Reassemble wheel to motor. Make sure
Tab
on wheel fits
into one of the
Motor Slots
.
4. Push wheel down until it is locked in place.
5. Check that wheel is properly positioned as shown. Press
Sections
into place if necessary. Make sure wheel turns
freely.
BLOWER
WHEEL
TAB
SECTIONS
SMALL DIAMETER
END
STOP
EDGE
RING
MOTOR
SLOTS
RETAINING
RING
¼
»