Nussbaum TSK 8000, Руководство по эксплуатации, журнал осмотров

Страница: 7 / 52

OPI_TOP LIFT TSK 8000_V3.2_EN 7
• After each set down of the vehicle, check the lift-
ing arm positions below the fixture points again
and adjust as required.
• When disassembling heavy, consider any possible
centre of mass shifts. The vehicle is to be appro-
priately secured using suitable materials (e.g. ten-
sioning belts, beams, etc.) against falling.
• After design and maintenance on load bearing
parts the lift must be inspected by a technical ex -
pert.
• Vehicles may only be attached at fixture points
approved by the vehicle manufacturer.
• The entire lifting and lowering process is to be
continuously observed.
• Initial access to the lift is only permitted after the
main switch has been turned off and secured,
and the operating lever is additionally secured
against unauthorised use.
Save these instructions!
1.6 Safety devices
Nussbaum has designed several saftety features
into each Lift to ensure safe and efficient opera -
tions under a variety of conditions. Warranties will
be voided and dangerous working conditions exist
if any of the listed devices are altered or disabled.
• Over-pressure valve
Hydraulic system fuse against over-pressure.
• Check valve
Secure the vehicle against unauthorised lower-
ing.
• Main switch with curtain lock device
Fuse to prevent unauthorised use.
• Command / downstream system with latch
Secure against unauthorised lowering of the lift.
• Deadman controls
Lift movement stops when the operating lever is
released.
• Lifting arm block
Secures the lifting arm against horizontal move-
ment in a lifted condition.