Nussbaum SPL 3200, Инструкция по эксплуатации и документация

Страница: 26 / 43

Pay attention, that the ”switch-off covering” is smooth and that the lift is
switched off when the covering is pressed up. This covering is for
switching off the lift while lifting the lift the same time a vehicle drives
against it from upper side.
• Lift and lower the lift with vehicle several times, tighten dowels a second time (M
= 80 Nm).
Initiation
Before the initiation a security check must be performed. Therefore use form:
First security check.
If the lift is installed by a competent, he will perform this security check. If the operator
installs the lift by himself, he has to instruct a competent to perform the security check.
The competent confirms the faultless function of the lift in the installation record and
the form for the security check and allows the lift to be used.
Please send the filled installation record to the manufacturer after installation.
Changing of the installation place
If the place of installation shall be changed, the new place has to be prepared according
to the regulations of the first installation. The changing should be performed in accor-
dance with the following points:
• lift carriage to medium height
• disconnect operating switch
• Take away current supply from lift
• Dismount carrying arms (remove circlips from carrying arm bolts, pull out carrying
arm bolts and take off carrying arm)
• Loosen long ratchet-rope
• Separate hydraulic connections between columns
• Dismount traverse support between the columns
• Empty oil-tank
• loosen dowels between base plate and floor and take off columns
• Transport lift to new installation place
• Install lift in accordance with chapter ”Installation and Initiation” of the lift.
Use new dowels, The used dowels cannot be used any more.
A security check must be performed before reinitiation by a competent. Use
form ”Regular security check”.
2 6
Instruction and Documentation
SPL 3200