Nussbaum MCS 7500, Инструкция по эксплуатации и документация

Страница: 21 / 52

Operating Instruction and Documentation
MCS 7500
Flex (Bluetooth)
- 21 -
6.Troubleshooting
If the lift does not work properly, the reason for this might be quite simple. Please check
the lift for the potential reasons mentioned on the following pages. If the cause of
trouble cannot be found, please call the technical service.
Problem: The Motors does not start!
Potential causes: Solution:
- no power supply check the main fuse
- the main switch is not switched on. check the main switch
- the fuse is defective check the fuse /exchange it
- the feed line is cut check the line
- the thermo-fuse is active let it cool down approx.10 min.
- the battery of the controllers is empty call the customer service
Problem: the motor starts, the lift does not lifting!
Potential causes: Solution:
- the vehicle is too heavy unload the vehicle
- the level of the oil is too low refill oil
- the hydraulic valve is defective call the customer service
Problem: The MCS does not lowered!
Potential causes: Solution:
- the MCS is standing on a obstacle single-mode operate
- the hydraulic valve is defective call the customer service
- the fuse is defective exchange the fuse
- the button „lowering“ is not pressed check the switch
- the holding valve is defective call the customer service
- the safety star system is always locked call the customer service
6.1 Lowering on a obstacle
The lift switched off if the lift is running onto an obstacle and out of the rule-window ± 50 mm.
6.1.1 Remove the obstacle
• Press the button “lifting ” in the single-mode. (see the chapter 5.4/5.5)
Keep an eye on it, at the singles-mode, that one MCS is lifted never too high,
otherwise the crash of the vehicle can occur.
6.2 Emergency lowering
A emergency lowering is an intervention into the control of the lift and can be done
only by experienced expert.
The emergency lowering must be carried in this order. Otherwise a malfunction can
lead it to damages or lead to danger for body and lives.
Every kind of external leakage has to be removed. This is necessary in particular
before an emergency lowering.
The emergency lowering may only be done by persons which are trained in using the
lift.