JUMBO 7000 HFK SCISSOR
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
20
11.2.
POSITION CONTROL STATION &
PLATFORMS
•
Front of the lift is the end with the hydraulic hoses
•
Control station can be mounted of either the driver or passenger
side of the lift.
[TR7]
•
Figure 7 shows the packing of the lift. The passenger side platform is
on the bottom beneath the driver side platform. The control station
is on top.
•
Set the control station on the appropriate side of the lift for
application. (Fig. 9)
•
Remove top of control panel
•
At this point, a qualified electrician should connect the electrical
power to the control station (Appendix 5)
•
Turn “Main Power Switch” on control station
(if applicable) to the
ON position.
•
Operate the “Lifting” handle
(Fig. 1) and raise the lift approximately
48” (1220mm) Raising the lift makes it easier to position.
Attention!
Position the pour spout at the top of
the container when pouring. This will eliminate
the “glugging” effect.
Figure 10
Figure 9
Figure 7
Figure 8
