2.
Insert the positioning tool into the
“top load” saddle and place them on
the pipe, after completing scraping and
cleaning operations (check installation
instruction of the fitting).
Note for article 12EIPRESTL142402:
Make
sure that the cap is competely tightened
until the stop.
3.
Pass the belt under the pipe and
insert it into the tightening clamp from
the bottom to the top, as showed on
the figure.
Care not to move the fitting in order not
to compromise the cleaning operation.
4.
Insert the belt up in the buttonhole
and then pull down to tighten the ‘top
load’ saddle on the pipe.
