Nuovo
Operating instructions for use
EASY-PRINT Sprinter R5/R6, Series 10
11
9 Packing, Transport, Storage
9.1 Packing
Check the scope of the delivery. In case of missing parts, please contact customer service at your nearest
service centre without delay.
Please dispose of the packing material properly.
9.2 Transport
The EASY-PRINT can be transported in any vehicle.
The load is to be secured reliably.
When lifting machines, pay attention to the centre of gravity.
The machine should be transported upright.
To avoid any damage to the machine (scratches, etc.), pay attention to proper packing (foam or similar).
Even for very small changes of location, the machine is to be separated from all external power supplies. Before
starting the machine again, connect properly to the mains.
When starting again, proceed only in accordance with the Instructions for use.
9.3 Storage
The machine should be stored in a dry area at a moderate temperature.
After lengthy storage of the machine, all internal parts must be inspected for corrosion or other damage before
operating. Clean or replace defective or corroded components.
10 Disposal
At the end of its lifetime, the machine is to be disposed of in accordance with national regulations.
We recommend contacting a specialized company to take care of disposal.
11 General technical data
Egg-Stamper:
Stamp head mounting
For 5 or 6 stamps produced
Quantity Stamp head holder
1
Stamp ink
Food grade ink
Control:
Print software
EasyUnit10 V01.00 FET2, Firmware V00.50 or higher
System
Microprocessor
Control voltage Us
1 x 110/230 V / 50/60HZ
Control element
Main switch, Single stroke button, Sealing cap aprox. Switch, Safety-Lid aprox.
Switch, aprox. Index.
Machine dates:
measurements in mm
(length x width x height)
approximately 500 x 250 x 250 mm
Weight
approximately 16 kg
