●
Fitting the battery
−
Remove the 2 screws from the battery cover with a screwdriver.
−
Remove the battery cover.
−
Insert the 3V, CR2450 Lithium battery,
paying attention to the polarity indicated
under the battery holder
(See diagram. 2).
−
A beep sound is emitted indicating the battery was properly inserted.
If you do not hear any beep sound after inserting the battery, immediately remove
it from the battery holder by using the supplied magnet (magnetic key). Check the
polarity before inserting the battery once again. If you still do not hear any beep
sound, check the operation by switching the collar on and off.
−
Put the battery cover back in place taking care to insert first the little pin at the
bottom of the battery cover (See diagram. 3).
−
Retighten moderately the 2 screws.
Diagram. 2
Diagram. 3
“+” terminal of the
battery downward
Replace the battery cover taking
care to insert first the little pin at
the bottom of the battery cover
Gb - 15
