User’s guide CANICOM 500 PRO – indice B
7/12
Retro-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off red button
(approx. ½
second).
How to use the remote control with a CANIBEEP RADIO PRO beeper collar
From the remote control you can:
▪
Locate the dog
: briefly or continuously press the yellow button
on the remote control to activate a beep
sound on the collar whenever your dog is pointing or moving.
▪
Deactivate temporarily the collar
: briefly press (1 to 2 seconds) the yellow button
:the collar is in
stand-by (it is temporarily switched Off: no beep sounds whether the dog is pointing or moving). The red
indicator LED is still flashing to indicate that the collar is not definitely turned Off.
▪
Reactivate the collar after it was temporarily deactivated
: if your collar has been temporarily
deactivated, press the yellow button
, you reactivate your collar on the last selected mode.
▪
Completely switch off the collar
: if you continuously press the yellow button
(approx. 5 seconds),
you will completely switch Off your collar (Warning: you will not be able to remotely reactivate it).
For further information regarding the CANIBEEP RADIO PRO beeper collar
(operation, settings, cautions for use, technical specifications), please read the
user’s guide provided with the collar.
●
Checking/replacing battery of remote control
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be prepared to replace
the battery.
To check the condition of the battery, turn On the remote control and look at the battery level indicator on the LCD
screen.
The symbols which appear indicate the following:
Battery fully charged
Weak battery: prepare to replace the battery
Dead battery: your CANICOM 500 PRO switches to safety mode and the system locks up. The battery must be
replaced.
NUM’AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible
with your product. You can purchase the suitable batteries from NUM’AXES or from your distributor.
Replace the old battery with a new one as follows:
On the back of the remote control, unscrew the screw and remove the battery cover.
Remove the old battery.
Insert the new battery (3-V Lithium CR2)
paying attention
to follow polarity indicated on the battery housing
(ref. Diagram 8).
Put the battery cover back in place.
Retighten the screw.
Check the remote control operates correctly.
WARNING
Make sure the polarity is correct
Diagram 8
Replacing battery of CANICOM 500 PRO