29.
Crossfader
–
Controls the blend between the two decks.
30.
High EQ
–
Controls the treble frequencies for the individual channels.
31.
Mid EQ
–
Controls the mid range frequencies for the individual channels.
32.
Low EQ
–
Controls the bass frequencies for the individual channels.
33.
Cue Gain
–
Adjusts the volume for headphone cueing in the software.
34.
Cue Mix
–
Adjusts the software’s audio output to the headphones, mixing between the cue output
and the master mix output.
PAD MODE COMMANDS
The lower row of pads has different functions depending on their mode: Looping Mode, Sample Mode, or
Hot Cue Mode. To select a mode, hold down the SHIFT button and press one of the lower pads. An LED
under the pad section indicates the currently selected mode.
Looping Mode:
Press
Shift + Loop In
to assign the lower 4 pads to the functions listed below:
Loop In
–
Sets the beginning of a loop. After a Loop Out point is set, when this button is pressed again,
it will allow for fine adjustment of the Loop In point.
Loop Out
–
Sets the end point for the loop. When this button has been pressed after a Loop Out point
has been set, it will allow for fine adjustment of the Loop Out point.
Reloop
–
When this is pressed inside a loop, this will turn the loop off. When pressed outside a loop,
this will activate the loop and start playback from its Loop In point. If a loop has not been set, this button
will have no effect.
Loop x1/2
–
Cuts the currently playing loop in half. Press
Shift + Loop x1/2
to double the length the
currently playing loop.
Sample Mode:
Sample mode uses the Traktor Pro 2 Remix Decks. To load samples and adjust volume,
use your mouse.
Shift + Loop Out
to assign the lower 4 pads to the functions listed below:
Sample 1 (S1)
–
Plays the sample assigned to Sample Pad 1.
Sample 2 (S2)
–
Plays the sample assigned to Sample Pad 2.
Sample 3 (S3)
–
Plays the sample assigned to Sample Pad 3.
Sample 4 (S4)
–
Plays the sample assigned to Sample Pad 4.
Hot Cue Mode:
Press
Shift + Reloop
to assign the lower 4 pads to the functions listed below:
Cue 1 (C1)
–
If a cue point has not already been set for the loaded track, this control will mark Cue
Point 1. If a cue point has already been set, this control will jump to Cue Point 1.
Cue 2 (C2)
–
If a cue point has not already been placed on the loaded track, this control will mark Cue
Point 2. If a cue point has already been set, this control will jump to Cue Point 2.
Cue 3 (C3)
–
If a cue point has not already been placed on the loaded track, this control will mark Cue
Point 3. If a cue point has already been set, this control will jump to Cue Point 3.
Delete Cue (C)
–
Hold this button, and then press one of the other pads in the row to delete its cue
point.
COMBINATION KEYS
Shift + Pitch Bend +
= Adjusts the range of the pitch fader in the software.
Shift + FX Control
= Selects the effect.
Shift + FX1
= Sets and starts playback of a 1-beat autoloop.
Shift + FX2
= Sets and starts playback of a 2-beat autoloop.
Shift + FX3
= Sets and starts playback of a 4-beat autoloop.
Shift + Tap
= Sets and starts playback of a 16-beat autoloop.
