Numark DM1090, Руководство пользователя

Страница: 12 / 16

DM1090
1
4 5 3
2
6
8 8 7 7 7 7
DM1090 REAR PANEL DIAGRAM
...
REAR PANEL: INPUTS AND OUTPUTS
1. AC Cord. See safety precautions on page 3 for
proper treatment of the power cord.
2. GND is the grounding lug for turntables 1 and 2
(phono inputs on Channels 1 and 2). Always use this
connection (your turntable cable should have a
grounding wire).
3. The Stereo Main Outputs are low-impedance
RCA connectors controlled by the Master fader.
4. The Stereo Zone Outputs are low-impedance
unbalanced RCA jacks controlled by the Z o n e L e v e l
control.
5. The Tape Outputs are low-impedance
unbalanced RCA jacks which output the program mix
and allow you to connect any recording device.
6. Mic 2 is a high-impedance 1/4” input.
7. Channels 1-3 Line Inputs are unbalanced RCA
jacks. The Line Input is selected with the toggle
switch on the front panel.
You can connect stereo audio from HiFi VCRs, cassette
and reel-to-reel tape decks, DAT machines, CD players,
laser discs, tuners, even synthesizers or other mixing
consoles.
N O T E : Plug mono audio sources into both Left and
Right inputs using a “Y” cable connector.
8. Phono Inputs on Channels 1 and 2 use
unbalanced RCA jacks. Your input signal is fed directly
to the D M 1 0 9 0's high-quality RIAA phono pre-
amplifiers so use this position only for moving magnet
cartridges. Line level sources will overload the sensitive
phono pre-amps and will sound very bad, so always be
sure to toggle the line/phono switch over to line before
connection of line sources.
Numark - The Proven Leader in DJ Technology
©1998 Numark Industries
12
http://www.numark.com