NUK e-Motion, Руководство по эксплуатации

Страница: 14 / 22

Commonwealth, Africa, Asia,
Great Britain, Middle East
Australia, New Zealand, China
Europe. South America, Africa
North, Central & South America,
Japan, South East Asia
1.
2.
3.
9. Power Supply
(Figure (2 ))
7.
9.1 Mains Operation
For mains operation use only the enclosed adapter;
model KSD 10-045-0800.
1. Open the battery compartment by the catch lock
(15) .
2. Insert the plug
(11)
on the
adapter (18) into the socket in
the battery compartment.
3. Close the battery compartment
again. Push both the “feet” on the lid into
the relevant recess and the motor unit and shut
the lid, ensuring the catch lock
(15) engages with
an audible click.
Note: The device should not be operated
without the battery compartment lid.
4. The mains adapter is supplied with an
Australian plug attachment, however if you
are travelling overseas, you can fit one of the
interchangeable plug attachments
(19)
to the
adapter so that it matches the power supply of
the country you are visiting (refer to the following
section)
5. Plug the mains plug (18) into a wall socket.
9.2 Interchangeable plug attachments
The mains adaptor is supplied with an Australian
type plug. Additional interchangeable plugs are also
included. You can use these to operate your breast
pump when overseas as follows:
Changing the Plug
1. Using an item such as a ballpoint
pen, press on the release catch
on the plug.
2. Slide the plug about 1.5cm
upwards and then remove it to
the front.
3. Position the interchangeable plug
attachment so that the
grooves on the attachment meet
the contacts on the adaptor.
4. Slide the plug attachment
downwards until the locking
mechanism clicks audibly into place.
9.3 Battery Operation
Battery operation requires three AAA, 1.5V batteries.
Rechargeable batteries should not be used to
operate the pump. Rechargeable batteries only have
a voltage of 1.2V; disposable batteries have 1.5V.
The lower voltage of rechargeable batteries means
that the pump under performs. Moreover, any
rechargeable batteries that may be inserted will not
be recharged.
The warning light
(13)
will warn you that the
voltage is too low when the pump is operated on
battery power. As soon as this light shines red you
need to change the batteries. When the batteries
are fully discharged the warning light
(13) can no
longer light up, as the pump switches off due to too
low voltage.
1. Open the battery compartment by the catch lock
(15) .
2. Insert the batteries, ensuring that they are
positioned correctly according to the + and –
symbols in the battery compartment.
3. Close the battery compartment. Push
both “feet” on the lid into the relevant
recess on the motor unit and shut
the lid, ensuring the catch lock
(15) engages
with an audible click.