NUK 10.252.090, Инструкция по эксплуатации

Страница: 21 / 92

17
Note: When rinsing with dishes (for
example), certain foodstuffs (e.g. carrot
juice) may discolour the parts or affect
their odour (e.g. fennel tea). This has no
effect on the fitness for use or safety of
the products.
3. Next, sterilise all components (see
“6.2 Sterilising”).
6.2 Sterilising
Before sterilising, clean as described in “6.1
Cleaning”.
Caution! In order to prevent product
damage, follow the manufacturer's
instructions when using any sterilisers or
sterilising solution.
1. Always dismantle the components before
boiling or steam-sterilising (temperature
above 80 °C) and leave them dismantled,
otherwise deformation may result.
2. Boil the parts for 5 minutes in a pan of
vigorously boiling water.
Ensure there is sufficient water in the pan
to avoid damage.
3. The sterilised components must be
thoroughly cooled down and
completely dry
before being
reassembled and used again.
Notes:
• Use a NUK Steam Steriliser. Follow the
instructions for use associated with the
device.
• For sterilisation in a microwave oven, we
recommend using the NUK Microwave
Steriliser (please follow the
manufacturer’s instructions for the
steriliser/microwave oven!).
7. Reassembling the pump
(Figures G to N )
1. Insert the pump rod 6 in the pump
diaphragm 7 . The lower end of the pump
rod 6 must fit in the hole of the pump
diaphragm 7 . (Fig. G ).
2. Position the pump diaphragm 7 in the
breast shield 2 and press firmly in place
(Fig. H ).
3. Insert the head of the pump rod 6 in the
pump lever 4 (Fig. I ).
4. Engage the handle fixture 5 in the catch
for the handle 8 (Fig. K ).
5. Insert the lip valve 9 in the breast shield 2
(Fig. L ).
6. Screw the NUK Breast Milk Container 10
onto the breast shield 2 (Fig. M ).
7. Put the silicone cushion 1 in the front of the
breast shield 2 and slip the edge of the
cushion over the breast shield (Fig. N ).
8. Using the breast pump
8.1 Expressing milk
Warning! As hygiene is so
important, please wash your hands
before expressing your milk, and
read the information in “9. Storing
milk” on page 18.
1. Place the funnel of the breast shield over
your breast.
– Make sure that your nipple is in the
centre of the silicone cushion 1 . This
prevents the nipple becoming sore.
– Gently press the breast shield 2 against
the breast so that the silicone cushion
1 fits closely and no air is drawn in from
the side.
– Always hold the breast milk container
and breast pump upright!
2. Press the pump lever 4 then slowly
release it.
Note: The further you press the pump
lever 4 , the greater the suction. To reduce
the suction, do not press the pump lever
4 all the way.
Mipu JOLIE Cluster 1.book Seite 17 Freitag, 23. April 2021 9:46 09