2. PUT THE WALL POST ONTO THE FIXED
PANEL, WITH THE HELP OF ANOTHER PERSON
PLACE IN POSITION ON THE BATH. USING A
SPIRIT LEVEL MARK THE POSITION OF THE
WALL POST ON THE WALL WHERE IT WILL BE
FIXED.
3. REMOVE THE SCREEN AND WALL POST
FROM THE BATH, TAKE THE WALL POST AND
PUT BACK INTO POSITION, USING A SPIRIT
LEVEL TO ENSURE THAT THE POST IS PLUMB
MARK THE POSITION OF THE 3 FIXING HOLES.
4. REMOVE THE WALL POST AND DRILL
WHERE MARKED FOR THE WALL FIXINGS.
REPLACE THE WALL POST AND SECURE
INTO POSITION.
5.WITH THE HELP OF ANOTHER PERSON PLACE
THE ASSEMBLED SCREEN INTO POSITION .
MARK THE POSITIONS FOR THE 3 SIDE FIXINGS
(SLIGHTLY OFFSET FROM THE WALL FIXINGS SO
YOU CAN FIX THE COVER CAPS)ENSURE YOU
DRILL THROUGH INTO THE FIRST PART OF THE
HOLLOW BOX SECTION OF THE ALUMINIUM
PROFILE ON THE FIXED SCREEN BEING CAREFUL
NOT TO GO THROUGH THE OTHER SIDE(DO
NOT DRILL INTO THE GLASS SECTION).DRILL
THROUGH USING A 3.2 mm BIT AND FIX USING
THE 10mm SELF TAPPING SCREWS.
6. FIT THE MAGNETIC SEAL BY SPLITTING THE SEAL
AND ATTACHING TO THE VERTICAL SIDES OF THE FIXED
AND HINGED PANELS THIS CAN BE DONE WITH THE
DOOR IN THE OPEN POSITION.THEN FIT THE
CONCERTINA SEAL BETWEEN THE HINGED AND END
PANELS. FIT THE BOTTOM SEAL AND BUTT THIS UP
AGAINST THE MAGNETIC SEAL AND CONCERTINA SEAL.
USING A SANITARY GRADE SILICONE SEALANT SEAL
DOWN THE WALL POST AND AROUND THE INSIDE AND
OUTSIDE AT THE BOTTOM OF THE FIXED PANEL. LEAVE
TO SET FOR 24 HOURS BEFORE USING THE BATH
SCREEN.
