Nuga NM-5000, Руководство пользователя, Страница: 13 / 24

ⴘⴙⴚ
How to Install the Product
Prepare product components
Take out the remote controller, power
cord, external projector, projector
pocket, and low frequency pad.
Connect to the connector
bay
ྙ
Remote controller
ྚ External projector
ྛ Low frequency pad
Connect components sequentially.
Connect the mat cable
Connect the power supply cable
for the sub mat to both the main
and sub mats as shown in the
picture.
Turn on the power supply
in the product
Turn on the power switch after the
power supply cord is connected to
the power input on the side of the
main mat.
Set temperature to the sub
heater
Turn the dialer to set the desired
temperature in the sub heater
attached to the side of the sub mat.
Tighten the product frame
to the mat
Attach the connecting band after
placing and tightening both the
main and sub mats to the product
frame.
Caution
Turn off the power switch when the
power is connected.
Otherwise, it might cause failure.
Caution
Keep the groove upward to the cable
connection.
Malfunctions might occur, if the groove
is not aligned accurately during the
cable connection.
NM-5000
HIGH
LOW
Product Installation and Preparations