Configuring a stereo pair
All nuPro X loudspeakers have the same functions and the con-
nections. Depending on placement and usage, configure your loud
-
speakers in one of the following ways.
Note:
Always connect your sources to the master loudspeaker
when using master/slave configurations! All settings are performed
on the master loudspeaker using the control pad.
Default setting: Cabled connection, left speaker as Master
Connect the two loudspeakers with the supplied SPDIF cable by
plugging one end of the cable in to the
Link Out
connector on the
left loudspeaker and the other end into the
Coaxial 1
connector on
the right loudspeaker. The left loudspeaker automatically config
-
ures itself as the Master and the right as the Slave. The loudspeak-
er pair is now configured and ready to use.
Variation: Cabled connection, right speaker as Master
Connect the two loudspeakers with the supplied SPDIF cable by
plugging one end of the cable in to the
Link Out
connector on the
right loudspeaker and the other end into the
Coaxial 1
connector
on the left loudspeaker. The right loudspeaker automatically config
-
ures itself as the Master and the left as the Slave.
Go to the
channel menu
on the Master loudspeaker and set the
channel to
right ch
, the master loudspeaker will now play back the
right channel. The Slave loudspeaker is configured automatically
and will now play back the left channel.
Variation: Wireless connection, left speaker as Master
In the setup menu of the left speaker, select
wls master
and con-
firm with
. On the right speaker you then select
wls slave
and
confirm. The loudspeakers will then connect to each other and the
left loudspeaker will now be the Master loudspeaker.
Variation: Wireless connection, right speaker as Master
In the setup menu of the right speaker, select
wls master
and con-
firm with
. On the left speaker you then select
wls slave
and
confirm. The right loudspeaker automatically configures itself as
the Master and the left as the Slave. Go to the
channel menu
on
the Master loudspeaker and set the channel to
right ch
, the master
loudspeaker will now play back the right channel. The Slave loud-
speaker is configured automatically and will now play back the left
channel.
Variation: individual configuration, wired connection
This option is recommended when the loudspeakers are used with
an external preamplifier. In the
setup menu
of each loudspeaker,
select
single
and confirm. This way, each loudspeaker can config
-
ured independently and receive separate audio signals.
9
nuPro X-8000 RC
· E12 · 03/2022 EN
