nubeca BA2110, Инструкция по эксплуатации

Страница: 8 / 15

Deflating Deflating To a fit pressure Inflating Start to inflate
13
In order to accelerate the measurement time for the systolic pressure more
than 180 mmHg, press and hold the memory button until the unit inflates 30 to
40 mmHg higher than your suspected systolic pressure if you know. ( The unit
will not inflate above 299 mmHg).
INSTRUCTIONS FOR SPECIAL CONDITIONS
4
Press the “START/STOP” button to turn off the unit.
Take a Measurement
2
The heartbeat symbol flashes once a pulse is detected.
The unit will anutomatically turn off after 2 minutes if you have
forgotten to turn it off.
The cuff is deflated automatically,
and all of the measurement
results are stored in the memory .
The “ ” symbol will be displayed
if
irregular heartbeat
is detected.
3
The blood pressure and pulse rate are displayed when
the measurement completed.
All display symbols appear on the screen. The cuff starts to
inflate automatically.
Press the “START/STOP” button.
1
Measurement starts while inflating.
NOTE: To stop the inflation or measurement,push the “START/STOP”
button,The unit will stop inflating and then release and turn off.
All symbols display
Start to inflate Deflating automatically
OR
"mmHg" display "kPa" display
OR
" " display
12
Proper Use of the Arm Cuff
8
Relax your arm, keep the
palm upward and the
fingers curving naturally,
then turn on the unit and
start to measure.
Wrap the cuff tightly around
your upper arm by using the
Velcro strip. Do not leave
any spacing between the
arm and the cuff.
7
1 ~ 2cm
The hose runs down the
inside of your arm. The
bottom of the cuff should be
approximately 1~2cm above
your elbow.
6
5
Put your arm through the
loop, then pull it up to the
position of your upper arm.
BA2110