6
16. 10. 20. Document Number 670901
Nuaire |
Western Industrial Estate
|
Caerphilly
|
CF83 1NA
|
nuaire.co.uk
FLAT2000 L/R
Installation Manual
14
Unit PCB Controls
Earth post on rear panel
Supply
Speed selector
L
N
Supply
L
Do not use
N
Do not use
6.2 Enabling the Heater
An integral heater is provided with this unit and can be enabled or
disabled by use of the red neon switch located on the side of the unit.
When the switch is illuminated, the heater is enabled and if the outside
air temperature falls below the thermostat set point, the heater will
activate. If the outside air temperature is above the thermostat set
point, the heater will not activate.
If the switch is not illuminated, the heater is disabled and heating will
not activate regardless of the thermostat set point or the outside air
temperature.
6.3 Thermostat Set Point
The occupier will normally require the heater to activate when the
outside air temperature falls below a predetermined point. This
predetermined point is factory set to 10°C, Nuaire recommend that the
thermostat be set at 10°C.
7.0 MAINTENANCE
It is important that maintenance checks are recorded and that the
schedule is always adhered to, in all cases, the previous report should
be referred to.
The maintenance requirements for this product can be found in the
“Product Safety – Essential Operational Checks” section, which is
located in this document and includes the replacement of the filter
(Our part number FLAT-FILTERKIT) every 12 months; this interval
may need to be shortened, if the unit is operating under adverse
environmental conditions.
Failure to do so may impair the performance
and energy efficiency of this unit.
8.0 WARRANTY
The 5 year warranty starts from the day of delivery and includes parts
and labour for the first year. The remaining period covers replacement
parts only.
This warranty is void if the equipment is modified without
authorisation, is incorrectly applied, misused, disassembled, or not
installed, commissioned and maintained in accordance with the details
contained in this manual and general good practice.
The product warranty applies to the UK mainland and in accordance
with Clause 14 of our Conditions of Sale. Customers purchasing from
outside of the UK should contact Nuaire International Sales office for
further details.
Failure to maintain the unit as recommended will invalidate the
warranty.
9.0 END-OF-LIFE AND RECYCLING
Ensure that Nuaire product is made safe from any electrical / water
/ refrigerant supplies before dismantling commences. This work
should only be undertaken by a qualified person in accordance with
local authority regulations and guidelines, taking into account all
site based risks.
Where possible Nuaire use components which can be largely recycled
when the product reaches its end-of-life:
•
Fans, motors, controls, actuators, cabling and other electrical
components can be segregated into WEEE recycling streams.
•
Sheet metal parts, aluminium extrusion, heating/cooling coils and
other metallic items can be segregated and fully recycled.
•
EPP, plastic ducting, nylon corner pieces, plastic heat exchangers,
packaging material and other plastic components can be
segregated into mixed plastic and widely recycled.
•
Cardboard packaging, wood, used filters and other paper
components can be largely recycled or fully processed in energy
from waste centres.
•
Remaining Items can be further segregated and processed in
accordance with the zero waste hierarchy. Please call After Sales
Support for further information on items not listed above.
10.0 AFTER SALES AND REPLACEMENT PARTS
For technical assistance or further product information, including spare
parts and replacement components, please contact the After Sales
Department.
If ordering spares please quote the serial number of the unit together
with the part number, if the part number is not known please give a full
description of the part required. The serial number will be found on the
identification plate attached to the unit casing.
Telephone 02920 858 400
