HOW TO OPERATE
IMPORTANT WHEN USING THE 12VDC VEHICLE ADAPTER:
DISCONNECT THE POWER
CABLE WHENEVER THE VEHICLE ENGINE IS TURNED OFF FOR EXTENDED PERIODS OF
TIME. THE POWER DOES
NOT
TURN OFF AFTER SWITCHING OFF THE ENGINE IN CERTAIN
VEHICLES. IF THE POWER PLUG IS LEFT CONNECTED, THE VEHICLE’S BATTERY MAY
BECOME RUN DOWN OR DAMAGED.
With normal use, air can get trapped in the hose. We recommend the following steps to purge
the air out of your system and get the maximum amount of pressure out of your new Turbo Tank
HVACR Rinsing Sprayer
PURGE AIR FROM SYSTEM:
To purge air, turn the unit on “II” or “I”(Diagram2). Point nozzle into
water tank and squeeze lever until steady stream of water exits the hose.
FOLLOW THESE STEPS AFTER EACH TIME YOU REFILL YOUR TANK:
1. Fill the tank with water and cap tank.
2. For 12VDC Vehicle Adapter Use: Connect to vehicle’s 12VDC power port. Turn unit on “II”.
For Battery: Charge battery and switch unit on to “I”.
For Optional Convertor: Plug into 115VAC power source and plug 12VDC vehicle adapter on
sprayer. Turn unit on “II”
3. Turn the power on and run for approximately 30 seconds or until a steady stream of water is
present.
4. Connect the mini-split wand or optional 39” wand to spray gun.
NOTE:
Please start the engine while using the device if you are not sure whether the capacity of
the vehicles battery is sufficient.
FOR 12VDC VEHICLE ADAPTER
(Diagram 1)
Plug into vehicle power port.
NOTE:
Some vehicles require that the
ignition be in the accessory position
FOR BATTERY
(Diagram 2)
Switch the power on “I” to use the
power of the battery
NOTE:
Charge 6 to 8 hours before
using the sprayer for the first time
Switch the power on “II” to use the
power of the car battery
